This is based on removing a Power Switch Board from an original PSP (1000 series)

There are no screws attaching the power switch board to your PSP console, they simply click into place but there is one cable ribbon attached so please bear this in mind when removing. The only tool you will need is a small flathead screwdriver.

First of all you need to take off the right hand shoulder button aswell as the metal clip in which holds down the rubber pad for said shoulder button. To remove the metal clip use your small flathead screwdriver and gently lift it up from where it connects to the PSP console.

When that is done you should then be able (with flathead screwdriver again) start to gently prise the PSP power switch board away, there is a small gap in which you can put your screwdriver to slowly lift it up. Do not lift up fully as it still has a ribbon cable attached, slowly turn over to one side and undo the brown cable clip, therefore releasing the cable and releasing the power switch board from your PSP console.