So, i am finally ready to put my Engine in my atv again and the new bushings that go in the Mount holes in the block are so small they are going to slop around. Even though the part # for them is from my 08 model the ones that come in when ordered are the updated ones for the newer blocks with smaller holes in the mount to prevent cracking.

Has anyone had to deal with this? my block is fine and no sign of issues. I also just rebuilt the bottom and top end twice and am not even going to consider getting updated engine halves. I would really prefer not to get that shitty overprice kit the service bulletin has where i have to order almost $300 in the new rubber mpunt with some sleeves. Has anyone found a sleeve size for just filling the gap so the new bushings fit?

any response would be great. as unlikely as it seems to get a response from any but 1 member of this board lately.