On the 8th day of Geekmas, I 3d printed Toji's Inverted Spear of Heaven from Jujutsu Kaisen. Post Processing on this one involved some gloop for the blade. Unfortunately I had to cut the blade so that it would fit on the Bambu. I did not sand this one down and post process, but doing so would have resulted in a cleaner look. The print took about 4 hours to complete on the Bambu P1P / P1S. The challenge here was deciding on the right filament colors to use. I opted for a combo of Gold and Silver filament.
You can see this one over on TikTok:
The breakdown:
💡
Geeky Inc Category - Anime
Original Appearance - Jujutsu Kaisen
Time to Print (on a Bambu P1P) ~ 4 hours
Post Processing - Minimal (But could have been more if I wanted a cleaner look)
Link to STL ($$$) - https://wirefram3d.com/collections/everything/products/inverted-spear-of-heaven-blade-file
Original Appearance - Jujutsu Kaisen
Time to Print (on a Bambu P1P) ~ 4 hours
Post Processing - Minimal (But could have been more if I wanted a cleaner look)
Link to STL ($$$) - https://wirefram3d.com/collections/everything/products/inverted-spear-of-heaven-blade-file
