Arduino BMP180 Digital pressure transducer circuit in proteus

In this article we will learn how to make Arduino BMP180 Digital Pressure Transducer circuit in proteus.
In the last post we will learn how to make Arduino BME digital pressure Transducer circuit in proteus. You can visit our website,
I hope you appreciate my work, let’s discuss about today’s project.

Components:

1. Arduino Uno
2. IC (BMP 180)
3. Resistors (330, 1k)
4. LEDs
5. Push button
6. Jumper wires

Construction…

• Connect SCL pin of IC with D19 pin of Arduino Uno
• Connect SDA pin of IC with D18 pin of Arduino Uno
• Connect VDD pin of IC with +3.3v
• Connect one side of resistor 330 with D8 pin of Arduino
• Connect 2^nd side of this resistor with +ve side of LED
• Connect –ve side of LED with GND
• Connect one side of 2^nd resistor 330 with D9 pin of Arduino
• Connect 2^nd side of 2^nd resistor with +ve side of LED
• Connect –ve side of 2^nd LED with GND
• Connect VCC pin of Arduino with +5V
• Connect one side of resistor with +5V
• Connect 2^nd side of resistor with one side of push button and then connect them with Reset
• Connect 2^nd side of push button with –ve side of LED and then connect them with GND
• Connect +ve side of LED with one side of resistor
• Connect 2^nd side of resistor with D13 pin of Arduino

Working…

The BMP180 is a digital pressure transducer. It is designed to measure atmospheric pressure and temperature and is often used in applications such as weather forecasting, altitude measurement, and indoor navigation.

Applications…

1. Weather Stations
2. Altitude Measurement
3. Indoor Navigation
4. Smartphone’s and Wearable’s
5. Automotive Applications

Advantages…

1. High Precision
2. Wide Measurement Range
3. Low Power Consumption
4. Temperature Measurement
5. Digital Interface

The post Arduino BMP180 Digital Pressure Transducer Circuit in proteus appeared first on projectiot123 is making esp32,raspberry pi,iot projects.