SPI Memory stimulus in proteus simulation

In this article we will learn how to make Spi Memory Stimulus in proteus simulation.
In the last post we will learn how to make Rain Alarm circuit in proteus simulation. You can visit our website,
I hope you appreciate my work, let’s discuss about today’s project.

Components which we use in this project are listed below:

1. IC (25AA640)
2. HDL
3. Jumper wires

Diagram of this project is below: 

Construction of SPI Memory stimulus in proteus simulation

• Connect the pin 3 & 7 with each other and then connect the to the +ve
• Connect the SCK pin of IC with the SCK pin of HDL
• Connect the SI pin of IC with the SI pin of HDL
• Connect the SD pin of IC with the SD pin of HDL
• Connect the CS pin of IC with the CS pin of HDL

Working of SPI Memory stimulus in proteus simulation

SPI is a common communication protocol used to interface microcontrollers and other digital devices with memory, sensors, and other peripherals. SPI memory devices, like SPI flash, are non-volatile memory chips that store data even when the power is turned off.

Applications of SPI Memory stimulus in proteus simulation

1. Consumer Electronics
2. Industrial and Automation
3. Automotive
4. Networking and Communication
5. Medical Devices

Advantages of SPI Memory stimulus in proteus simulation

1. Ease of Integration
2. Low Pin Count
3. High-Speed Data Transfer
4. Wide Range of Memory Sizes
5. Low Power Consumption

The post SPI Memory stimulus in proteus simulation appeared first on projectiot123 Technology Information Website worldwide.