Hi

I have been playing around with Orange Pi for , had Openplotter on a OrangePi PC 2 Plus 2G ram 8G Emmc, but never got installed in the boat.
Now I got a question on Facebook where I answered that  this BTT Pi 3d printer Klipper board could be a good board... so I should test it myself...before causing problems!! 

The board: https://biqu.equipment/collections/contr...d_source=1

And it does not include Can bus, but has port for an Can accessory: https://biqu.equipment/collections/contr...2289867874

So I got the image for the BTT CB1 that is working with BTT Pi board:  https://github.com/bigtreetech/CB1

I think it is an Armbian I tried Armbian Bookworm but was not lucky...

I'll will follow the OPI 5 install maybe, and adapt things

This board is close to OrangePi Zero 2w.. I have a few.. try them later maybe!

I'll report more later  /bektorkhan