High Pressure | D.E. coated with normal build-up of pool dirt, algae, etc. Overcharge of D.E. Restriction in return line caused by small eyeball fitting Partially closed valve on return line | Bump
Bump-Drain-Recharge Change to larger size fitting
Open valve |
Return Flow drop off | D.E. coated with normal build-up of pool dirt, algae, etc. Pump strainer basket clogged Skimmer basket clogged Pump impeller vanes clogged
Air leak on suction side of pump
Electric motor running less than max. RPM | Bump
Clean Clean Clean with stiff wire brush through pump strainer opening Check cover gasket, hand knobs, hose, clamps, etc.
Replace or tighten
Consult pump/motor troubleshooting guide
Most problems due to:
- Undersized/improper wiring
- Power cut-backs
- Both 1 & 2
|
Short Cycles | D.E. loaded to capacity with pool dirt, algae, etc. Bumping incorrectly
Bump handle bent Pump output exceeds design flow rate of filter Algae present | Bump-Drain-Recharge
Slow down stroke – quick stroke up. Repeat 6 times Check and straighten, or replace Check GPM/LPM output. Regulate pump output to max. filter GPM/LPM rating Super-chlorinate, Bump- Drain-Recharge
|
Short Cycles continuing after Bump-Drain-Recharge | Contaminated or clogged Flex-Tube braids due to:
- Natural build-up of chemical deposits
- Running D.E. charge too long with build-up of live algae present
- Operating filter without D.E.
- Operating filter too long without D.E. after the pump starts. D.E. must be added
- immediately after filter is filled with water and a steady stream is coming from the pump
| Clean tube nest (2 methods)
- Detergent Cleaning: Remove tube nest, hosing it down with forceful stream of clean water. Soak tube next in strong solution of laundry detergent and warm water. Hose down again.
- Chemical Cleaning: Use water and muriatic acid solution to chemically dissolve contaminates. Consult with pool dealer.
|
Short Cycles when vacuuming | Dirty Water Live, vigorously growing algae Alum or flocking agents clogging the filter | Bump-Drain-Recharge more often Add chlorine, then vacuum Vacuum to bypass filter, avoid using flocking agents |
D.E. leaking into pool through return lines | Opening or tear in one or more Flex-Tubes Rip or hole in diaphragm gasket Worn or loose-fitting diaphragm gasket Loose bolts on tube nest plates | Replace Flex-Tube
Replace gasket
Replace gasket
Tighten bolts |
D.E. leaking into pool through skimmer or main drain | Filter check valve worn or stuck open | Clean and/or replace valve |
Hard Bumping | Caking of D.E. under tube sheet. Due to build up sun tan oil, hair, floating particles binding together to form clay-like substance Overloaded with D.E.
Due to improper draining of last charge of D.E Filter runs too long between bumping
| Bump-Drain-Recharge more often. Reduce use of oils
Bump-Drain-Recharge with correct amount of D.E
Bump more often
|