Hair straighteners are a popular way to get sleek, straight Hair. However, if you use them incorrectly, you can damage your hair. Here are 5 common hair straightener mistakes to avoid:
1. Using too high heat setting
Using Heat setting that is too high can damage your hair. Ideal heat setting for your hair will depend on its thickness and texture. If you are not sure, it is always best to start with a lower heat setting and gradually increase it as needed.
2. Not using heat protectant
Heat protectant help to shield your hair from the heat of the hair straightener. It is important to apply heat protectant to your hair before using a hair straightener, even if you are using a low heat setting.
3. Not sectioning your hair
Sectioning your hair helps to prevent you from over-processing it. When you straighten your hair, divide it into small sections and work on one section at a time.
4. Not cleaning your straightener
A dirty straightener can transfer dirt and bacteria to your hair. It is important to clean your straightener regularly with a soft cloth and rubbing alcohol.
Learn & Earn -- Visit Here
5. Using hair straightener on wet hair
This is one of the biggest mistake people make when using a hair straightener. Wet hair is more fragile than dry hair and is more likely to break when it is subjected to heat. Always blow dry your hair until it is completely dry before using a hair straightener.
By avoiding these common mistakes, you can help to protect your hair from damage and achieve healthy, straight hair.
Additional tips for using hair straightener safely and effectively:
- Start with clean, dry hair.
- Use a wide-tooth comb to detangle your hair before straightening it.
- Apply heat protectant to your hair from root to tip.
- Start with the lowest heat setting and adjust it as needed.
- Straighten your hair in small sections.
- Don't over-process your hair.
- Let your hair cool down completely before styling it in any other way.
This post first appeared on Ayurvedic Medicine For Diabetics: Manage Your Blood Sugar Naturally, please read the originial post: here
