The Oumier Wasp Nano RDA V2 is the newest addition to the Wasp family!

The original Wasp Nano RDA was a success and this enabled the creation of the Wasp Nano RDTA, Wasp Nano Squonk Kit, Wasp Nano RTA, Wasp Nano RTA V2 and the MTL RTA version.

What Is New For The Oumier Wasp Nano RDA V2?

This to me looks very similar to the original Wasp Nano but with a few sneaky little tweaks!

The first main update is the ability to use either a single or dual wire coil build in here.

The original Wasp Nano was a single coil setup only but this version has two different top caps to allow single or dual coil builds. Both caps are included in the kit!

Also the deck design is very different from the original with 4 posts to allow for up to 2 coils.

The airflow has been updated to 4 airflow inlet slots – one pair each side – I am not sure if this is still adjustable? I would imagine rotating the top cap should open / close the airflow slots as required.

Following the tradition this is able to function as a standard Dripper RDA or if you install the included Bottom Feed hollow 510 pin you can also use this as a squonker.

There are 6 colours to choose from: Black, Gold, Stainless Steel, Blue, Red and Green.

Kit Includes

• Oumier Wasp Nano V2 RDA
• 0.28ohm coil x2
• 2x Post Screws
• 1 deck screw
• Silicone rings
• Screwdriver
• BF hollow 510 Pin
• Cotton
• Extra top cap
• User manual

Oumier Wasp Nano RDA V2 Specs

• Size: 24mm diameter
• Single or dual coil configuration
• Squonk 510 pin compatible
• 2 top cap options for single or dual coils (both included in kit)
• Side adjustable airflow

I do hope this has all the features of the original as that was a classic for a tiny simple RDA!

Let me know your thoughts on the Oumier Wasp Nano RDA V2 in the comments below!

The post Oumier Wasp Nano RDA V2 Preview – Single & Dual Coils? No Problem! appeared first on Ecigclick.