Hi Peeps,
it's been a while since I was on here for sure. So long in fact that I've forgotten how to use the Aurora Installer software :o Anyway after much messing about installing it onto a new laptop and eventually finding the lead to connect it I sorted it out, I think :confused: Anyway what I'm trying to do is limit the output of my inverter to 2500W so I copied the curve that was installed up to point 13 which was 1950W then set point 14, 14 and 16 at 2150W, 2250 and finally 2500W.
Seems to have worked but will it limit the inverters output and where will the extra power go:confused: I'm guessing it'll be dissipated as heat via the dump loads:idea:
Need to limit the output cos I've AC coupled it via an Outback GVFX 3048 and it's not happy when the turbine is producing over 3kW.
Cheers, Paul
it's been a while since I was on here for sure. So long in fact that I've forgotten how to use the Aurora Installer software :o Anyway after much messing about installing it onto a new laptop and eventually finding the lead to connect it I sorted it out, I think :confused: Anyway what I'm trying to do is limit the output of my inverter to 2500W so I copied the curve that was installed up to point 13 which was 1950W then set point 14, 14 and 16 at 2150W, 2250 and finally 2500W.
Seems to have worked but will it limit the inverters output and where will the extra power go:confused: I'm guessing it'll be dissipated as heat via the dump loads:idea:
Need to limit the output cos I've AC coupled it via an Outback GVFX 3048 and it's not happy when the turbine is producing over 3kW.
Cheers, Paul
