I’m so glad that you’re back to check out today’s project! Yesterday on QUILTsocial I demonstrated how to use HEIRLOOM Assorted Plastic Templates to cut applique shapes and we made a cute little bear block. Today’s post is all about rulers!

One of the go-to rulers that I have in my collection is the OMNIGRID Ruler – 12½” x 12½”. This great ruler can be used for cutting and squaring, and has both right and left hand numbering. The black and yellow double sight lines are great for easy viewing when working with light and dark fabrics.

There are two reasons why I like this ruler.

The first reason is that it measures 12½” square. Any ruler that has an extra ½” is my friend. That extra ½” makes it so much easier to square off a block since many blocks (especially those in block exchanges) are 12½” unfinished.

The second reason why I like this particular ruler is because it has a nice long diagonal line from corner to corner. There are two benefits to that diagonal line:

1. You can use the diagonal line to help square off a block by lining it up with seams in the center of a block as shown below:

2. The second benefit is that it is great for cutting right angle triangles from both wide and narrow fabric strips.

Here’s how I use the 12½” square ruler when working with leftover 2½” strips such as those from bindings and jelly rolls.

Note: You can use any strip width you wish. Any width you use will make a great quilt block and will result in a fun quilt. Just make sure that the strips that you use for your block are all the same width to start with.

To make our block today, we’re going to use 2½” strips. Sew four strips together in a step-wise fashion as shown in the following picture.

Line up the OMNIGRID ruler’s diagonal line with the bottom edge of the your Strip Set.

When ready, make your first cut along the side of the ruler to remove the step-wise edge of your strip set. Go boldly, and just do it!

You can see that by sewing the strips together in a step-wise fashion there is less wasted fabric when you trim.

After your first cut, slide the ruler over and place the ½” line along the side that you just trimmed. The diagonal line is still lined up along the bottom of the strip set.

Next, cut along the other side of the OMNIGRID ruler to make your first triangle. Continue along the strip set to cut more triangles. You’ll need to flip the ruler over to cut each consecutive triangle. Always make sure to line up the bottom edge of the strip set with the diagonal line on the ruler.

When you’ve cut four half square triangles you’re ready to assemble a block. Sew the triangles together on their square angle. As you can see, putting four triangles together in this way gives you a gorgeous quilt block!

The completed block measures 16½” x 16½” and it was easily achieved using the OMNIGRID Ruler – 12½” x 12½”.

This block is VERY versatile!! Sew together four rows consisting of five blocks each and you’ll have a single size quilt top in no time flat! Even better, sew together five rows of five blocks each to create a double size quilt.

The possibilities are endless with this block.

Thanks for joining me today and come back tomorrow when I’ll show you how to make a 3D block!