For sure, one of the best software for surfacing thin inventory and Planing Thin Strips is a drum sander. However given the truth that even the smallest and most elementary models value over $seven hundred, it’s not a software everybody can justify having of their outlets. Fortunately, there’s a terrific various: the planer. However don’t run out to the store and begin planing veneer simply but. Most planers aren’t very glad operating inventory that’s lower than 1/four″ in thickness. As soon as the wood will get that thin, it turns into very mild and versatile and there’s a very good probability it’ll be sucked up into the planer blades which can shortly flip your fancy planer right into a wood chipper.
Fortunately, with a bit of further help, we will safely run thin inventory via the planer for veneer, bent lamination, or anything requiring surfaced materials underneath 1/four″. All it takes is a store-made sled consisting of a bit of three/four″ plywood (or any sheetgood), and a pair thin items of strong inventory that act as a stop. Utilizing CA Glue, I connect the small strips to at least one finish creating an L-formed stop. The grain ought to run entrance to again for greatest outcomes. As soon as the stops are hooked up, think about coating the floor of the sled with end to seal the floor. The tough-sawn Strip can then be dropped onto the sled with one finish nested within the L-formed stop. The opposite finish will get a small dab of CA Glue as a way to forestall lifting on the entrance. After planing, use a putty knife to pop the strip off the sled. When you sealed the floor, the glue shouldn’t do a lot injury.
So how far can you’re taking this course of? I did a check run with my sled and I used to be capable of obtain a thickness that’s fairly near business veneer! However I did cheat a bit of since my shellac sealer was nonetheless only a bit cheesy. That gave the strip full help throughout the complete size which undoubtedly skewed my outcomes. For sensible functions, I wouldn’t go an excessive amount of thinner than 1/eight″ with this system however you’ll have to check for your self to seek out the decrease restrict.
Are you interested by studying how you can cut Thin Strips utilizing your desk noticed? Take a look at this video!
Shaping a Maloof-Impressed Sculpted Rocker Spindle