Get Even More Visitors To Your Blog, Upgrade To A Business Listing >>

Cutting Thin Strips at the table saw

Resawing skinny Inventory and chopping skinny strips is usually the area of the bandsaw. And whereas I think about the bandsaw to be an important store software, not everybody has one. Moreover, as a result of the bandsaw leaves a considerably tough floor behind, you’ll want a option to clean that skinny inventory earlier than you need to use it. So it’s in all probability value contemplating an alternate choice that kills two birds with one stone: using a extra widespread device that leads to a smoother cut. So let’s look at a number of methods you need to use your table saw to cut skinny strips.

First, the Drawback!

Why can’t we simply set our table saw fence for three/sixteen″ and run the piece by way of? The first cause is security. With so little area between the fence and the blade, it turns into troublesome to successfully push the inventory previous the blade and kickback can simply happen. So the secret is to discover a strategy to both push the inventory by way of safely, or just push the reference stop to the LEFT aspect of the blade as an alternative of the proper.

Options

Fancy Push Blocks

grr-ripperIn the event you occur to have a  MicroJig GRR-Ripper, you already know that skinny inventory isn’t a lot of a problem. This nifty push block holds the off-cut securely and pushes it safely previous the blade. The unit comes with the capability to tear strips right down to 1/four″ and a particular add-on is out there for strips at skinny as 1/eight″. If one have been so inclined, a store-constructed answer may be devised that accomplishes one thing comparable.

Thin Strip Jig

thin-strip-jigRight here’s an excellent easy jig comprised of a bit of MDF or plywood scrap that contains a hook glued onto one finish. That hook is there to push the inventory by way of the cut safely. After you have the jig made, merely set it towards the fence and regulate the fence so the hole between the blade and the jig is the desired strip thickness. Put the inventory towards the jig and ensure it’s absolutely-seated in the hook and punctiliously push it via the saw. So easy but so efficient. The one downfall of this system is that you simply’re considerably restricted in the measurement vary of inventory. If the board will get too giant or too lengthy, it may be troublesome to regulate safely.

The Left-of-the-Blade Cease

thin-strip-magnetWhereas placing the off-cut strip to the left of the blade is certainly safer, you’ll should re-modify your fence each time to get a number of strips of the similar thickness. If we’ve got a stop in place to assist index the cut, the course of turns into straightforward and repeatable. You should use one thing so simple as a bit of scrap wood clamped to the table, however my most popular stop is a magnet. A easy MagSwitch magnet will do the trick fairly properly. With the stop in place, all it’s essential to do is put your workpiece towards the stop and punctiliously nudge the fence in place on the proper aspect. Simply watch out to not by chance push that magnet out of place. That is my favourite technique primarily as a result of it’s straightforward to arrange and doesn’t pose any limits on the measurement of the workpiece or the measurement of the ensuing strips.

Different Choices

thin-rip-jigWhereas not mentioned in the video, there are store-made and business jigs out there that match into the left miter slot of the table saw. They are often adjusted for numerous thicknesses they usually work fairly well. So in case you plan to do a variety of this, it’s not a nasty concept to construct or purchase a jig.

Fascinated with an alternate method to floor and clean skinny inventory? Take a look at this video!



This post first appeared on Woodworking Made Easy - Tips, Projects, Plans And Video, please read the originial post: here

Share the post

Cutting Thin Strips at the table saw

×

Subscribe to Woodworking Made Easy - Tips, Projects, Plans And Video

Get updates delivered right to your inbox!

Thank you for your subscription

×