I’ve been trying to configure the Epever XTRA4215N so the load circuit runs 24/7 to power a small circuit with a couple of cameras and motion sensors. Aim is to keep these operating with a LV safety while gone and main DC turned off. Easy with my old CC but I can’t figure how with the EPEver. Despite programming it as manual and just turning it on from the front panel, it just seems to turn off sometimes. I’m not sure if some of the timer features are clicking in but I’ve program it (through the remote interface) to be manual only so assumed it would just stay on when turned on.
Anyone trying something similar or hints? I don’t want to run it directly without adding some Low Voltage protection in case something goes wrong.
Anyone trying something similar or hints? I don’t want to run it directly without adding some Low Voltage protection in case something goes wrong.