Sold Kontronik Progdisc Aircraft – Electric – Power Systems (FS/W). SOLD – Kontronik PROGDISC. I bought it last month thinking I needed it for setting up my Heli Jive. The box has been openned and that’s it. The KOSMIK can be parameterized using the KONTRONIK PROGDISC. This allows to change individual parameters and helps to adjust the KOSMIK to your.

From here you can: After choosing the configuration option you arrive at the main menu. Every landing is mandatory. Canting to the right, i. Originally Posted by mkovalcson. P-Part 14 The proportional part of the curve can be strengthened or allayed.

Das Timing kann hier angepasst werden. Still has protective film over the LCD.

Der folgende Bildschirm wird angezeigt Der Ablauf der Konfiguration entspricht den, unter 6. Sent from my iPhone using Tapatalk. Options Quote message in reply? There is a whole lot of light flashing going on on the kojtronik, and a progress bar of a few seconds, and only at the end of that it’ll give me that message instead of going to the programming menus.

Kontronik ProgDisc (for programming Jive, Jazz, Koby, HeliJive) – RC Groups

The procedure equals the one described in 6. I hear that just worried if I purchased it will end up just a waste of money now that I hear it’s going to be discontinued. Some time ago we started developing a new programming and update unit Order No.

Secondly after doing this then pwr up, should see it. Let’s hope the component they can’t source IS the progdisc. The update mode is confirmed by changing red and green LEDs.

In order to kontrronik able to post messages on the HeliFreak forums, you must first register. They should be disposed properly and environmentally safe after their service life.

Remove Advertisements Sponsored Links. Bei Bedarf kann dieser Vorgang wiederholt werden.

Please enter a valid email address for yourself. Changing the neutral point makes sense, if for example external influences make reading the display hard.

I just purchased a Kosmik and a Progdisc a week ago and after using the Progdisc a couple of times I’m looking forward to seeing the replacement. After connecting and starting again you can proceed with programming the respective mode. Set Full Gas Position Defines the stick postition for full gas.

This procedure can be repeated if desired. This will be operated customer friendly from the PC and also be much cheaper.

The factory setting for the menu kontronikk is English. Use a real email address or you will not be granted access to the site. Remove Advertisements Sponsored Links. They are no longer are able to source a component needed to manufacture the current ProgDisc.

Note that passwords are case-sensitive. Folgende Fachgrundnormen wurden herangezogen: When I connect the ProgDisc updated to firmware 1.

KONTRONIK PROGDISC Bedienungsanleitung KONTRONIK PROGDISC Manual

Additionally, the corresponding sender profdisc to be switched on. It’s a community-based project which helps to repair anything. The setting is displayed at the lower end of the display. In order to be able to post messages on the HeliFreak forums, you must first register. Repeated enter allows new adjustment.

I wonder if it will use the master port or the USB port to connect to the Kosmik.

Kontronik ProgDisc – RC Groups

This procedure can take around five to six seconds. Password Please enter a password for your user account. The ESC can only be used in environments in which no discharge of static electricity occurs. Quote message in reply? For online updateable ESCs this choice knotronik not necessary.

But still, you cannot upgrade the software for the jazz and the jive with the progdisc. Last kontrnik by rablett; at Beratung, Technische Hilfe, Hotline Hotline: Reset Battery Type Resets all parameters to default.

Use a real email address or you will not be granted access to the site.

The post KONTRONIK PROGDISC PDF appeared first on David Waters.