Pensacola FL Aluminum Driveway Gates
Custom Designed Plasma Cut Logos & Mexican Clavos
Here’s a 20′ dual swing aluminum driveway Gate project recently completed by JDR Metal Art for a Pensacola, Florida property entrance.
Plasma Cutting The Gate Logos
Custom Plasma Cut Gate Logo
Logos and signs cut from 3/16″ thick aluminum sheet, marine grade 5083.
Gate Logo Frames
Using a bender to roll the frames for the gate logos from 1/4″ thick by 2″ wide flat bar.
Sawing The Gate Frames
Using a horizontal band saw to cut 45 degree miters into the ends of the tubes which get mitered and welded together. 2 x 2 x 3/16″ aluminum frame material.
Parts Prepared for Fabrication
All materials are saw and Plasma Cut, then prepared for fabrication.
Framing Up the Gates
All welded areas are degreased with acetone, mitered with a flap disc and scoured with a stainless steel wire brush prior to preheating and welding.
Tack Welding Pickets In Place
All the pickets were placed first, then the logos placed on top and the spots traced onto the pickets before cutting them again.
This post first appeared on Custom Driveway Gates By JDR Metal Art, please read the originial post: here