As discussed in my last post about the categorization of Automation. In this post i am ellobrating more about the details.
Process Automation:
Typicaly talks of automation of a process, say for example
-- Creations of 2D drawings from a set of 3D models.
-- Generation of Bill of material
-- Extracting cost related information from the design
-- Creations of PDF files from the 2D drawings.
and similar activities which talk about a process.
Decisions Automation:
Typicaly talks about the making of decision or selections process where a logic is involved. A logic based selection automation can be made feasible if we can figure out the selection criterias for the same in advance; say for example.
-- Selection of a bearing in a design based on the parameters extracted from the the shaft design
-- Selections of available standard parts
-- Calculations & Loops in design.
and similar activities which relate to the if and then loop.
Process Automation:
Typicaly talks of automation of a process, say for example
-- Creations of 2D drawings from a set of 3D models.
-- Generation of Bill of material
-- Extracting cost related information from the design
-- Creations of PDF files from the 2D drawings.
and similar activities which talk about a process.
Decisions Automation:
Typicaly talks about the making of decision or selections process where a logic is involved. A logic based selection automation can be made feasible if we can figure out the selection criterias for the same in advance; say for example.
-- Selection of a bearing in a design based on the parameters extracted from the the shaft design
-- Selections of available standard parts
-- Calculations & Loops in design.
and similar activities which relate to the if and then loop.
